![]() ![]() You can even telnet localhost 4532 and control your rig there while programs are running. I that way you do not have conflicts with CAT serial port as only ONE rigctld is accessing your rig via serial interface and it is sharing the information to all programs.Īll programs can the run at the same time ! Instead all other programs should use "net rigctld" as rig and localhost:4532 as the port. ![]() You should NOT set up your yeasu with similar parameters in those program's setups!! When you are working with cqrlog AND fldigi OR wsjtx, OR any other program that uses rig CAT. Then you are sure TRXcontrol settings are ok. You are now ready to tell Fldigi to use PulseAudio for audio and to connect Fldigi to your USB soundcard. Again, you’ll know Fldigi is properly configured when you see the correct frequency displayed in Fldigi. Go to the Configure->Rig Control menu and click on the checkbox to use Flrig. Then start cqrlog again.Īnd now you should see similar line than yours: Next, configure Fldigi to use Flrig for Rig Control. such as programming the Yaesu FT 991 with WSJT-X, yours is the best, clear, best impossible, in minutes. I can validate that my FT-991 with fldigi and WSJT-X both are stable and solid. So many times that you get "no processes". It has the FT-991A support built in for rig control and I have it controlling the radio, but have not yet been able to connect to a gateway yet. If there is no rigctld-line start cqrlog. To make sure no rigctld is running at that point give from console: TRXcontrol/radio one parameters: 38400, default, default, default, default, default, default should give you that. So In cqrlog you should use same parameters. usr/bin/rigctl -m 135 -r /dev/ttyUSB0 -s 38400 -v Transmit lower start tone - checked Transmit upper start tone - checkedTone Duration: default to 4 seconds Allow manual tuning - NOT checked(This will keep you from accidently clicking on the waterfalland messing things up) RIG Control configuration parameters This will primarily control your PTT function. The transition levels can be adjusted on the 'Signal Level' configuration panel. RED - signals too high, danger of decode errors. ![]() YELLOW - signals level high, but still OK. I have written about this subject here for some times. GREEN - signals are in the correct range. Just add -wsjtx at the end of existing text. If you get text like that then you can change cqrlog prferences/trx control/path to rigctld to point this file. If you have installed WSJT-X 1.8.0 it installs the latest (stabile) version, but it is named as rigctld-wsjtx. If you have 3.1 it is the latest official. Warranty not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. This is free software see the source for copying conditions. It looks like you have version 3.1 installed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |